Kingspan Kooltherm
Kingspan Kooltherm K8 Cavity Board
- Australian made, from Melbourne
- Matched accessory for a complete, airtight install
Kingspan Kooltherm K10 G2W White Soffit Board
- Available from R1.1 to R4.6 to suit different climates
- Australian made, from Melbourne
Kingspan Kooltherm K10 G2 Soffit Board
- Australian made, from Melbourne
- Matched accessory for a complete, airtight install
Kingspan Kooltherm K3 Underfloor Insulation
- Rigid phenolic board with one of the lowest thermal conductivities available
- Australian made, from Melbourne
Kingspan Kooltherm K17 Insulated Plasterboard
- Australian made, from Melbourne
- Matched accessory for a complete, airtight install
Kingspan Kooltherm K12 Framing Board Insulation
- Purpose-made fixings for a secure, correct installation
- Australian made, from Melbourne
No products match these filters.
The Kingspan Kooltherm Insulation range is an extensive range of super high performance rigid thermoset phenolic insulation. Kooltherm Insulation is suitable for roofs, walls and floor areas in both residential and commercial applications. Contact us on 1300 729 639 for commercial project pricing!
Kooltherm Features
• Fibre-free, closed cell insulation core • Easy to handle and install • No CFC or HCFC used in manufacture • Has zero ODP and low GW • Water vapour resistant • Compliant with AS/NZS 4859.1 • Made in Australia
Kooltherm 10 Year Warranty
Kingspan Kooltherm has an outstanding thermal performance, with a 14% increase in R-value performance than other PIR products. Kooltherm products can be expected to have a long life of service. Their durability depends on the supporting structure and the conditions of its use. Kooltherm insulation is covered by a 10 year warranty for both residential and commercial installations. This is subject to the terms of the Kingspan Kooltherm warranty document which is available upon request. This range includes some of the most thermally efficient insulation products on the Australian market. Contact us on 1300 729 639 for commercial pricing!
Kooltherm Application and Handling
It is considered best practice to tape joins of Kooltherm boards with 48 mm wide reinforced aluminium foil tape. When taping a plastic squeegee or blade must be used to apply appropriate pressure to the tape. Surfaces must be dry and free from dust, oil or grease prior to taping. Cutting should be carried out either by using a fine toothed saw, or by scoring with a sharp knife, snapping the board over a straight edge and then cutting the facing on the other side. Ensure accurate trimming to achieve close-butting joints and continuity of insulation. According to quantity, the boards are supplied in packs, labelled and shrink-wrapped in polythene.
The packaging of Kingspan Kooltherm® should not be considered adequate for long term outdoor protection. Ideally boards should be stored inside a building. If, however, outdoor storage cannot be avoided then the boards should be stacked clear of the ground and covered with an opaque polythene sheet or weatherproof tarpaulin. Boards that have been allowed to get wet should not be used.
Tell us your roof type, postcode and rough area, and we'll narrow it to a couple of options.